Remote Start DIY Wiring Guide 2006-2010 Yaris

[WestCoast]

Thank you so much CTScott, I found it after I opened the CM6200 module.
Now, the wires have been connected, and I have tried to lock and unlock the door, works great.
When the car was running after I take off the key, I still can use remote start to shut it off. But the weird thing is, after I push the remote start button to start my car, the car just flash twice, then nothing happen, however the car will immediately start after I plug in the key without turn the key(just in the lock position even not in the ACCE or ON position).

[CTScott]

Originally Posted by WestCoast

Thank you so much CTScott, I found it after I opened the CM6200 module.
Now, the wires have been connected, and I have tried to lock and unlock the door, works great.
When the car was running after I take off the key, I still can use remote start to shut it off. But the weird thing is, after I push the remote start button to start my car, the car just flash twice, then nothing happen, however the car will immediately start after I plug in the key without turn the key(just in the lock position even not in the ACCE or ON position).

I have only installed a remote starter on a Yaris which has the engine immobilizer and therefor required the key bypass module. It sounds like even though yours does not have the immobilizer that the ECM wants to see the "unlock warning switch". It is a 2 pin connector on the ignition switch with a yellow and a white/black wire. As a quick test, just jump the yellow to the white/black by shoving a piece of wire in the back of the connector. If it remote starts with that jumped, then you will need to hook the yellow wire to the start #2 output of the remote starter.