 |
 |
|
|
02-17-2014, 03:33 PM
|
#3 |
 Drives: Yaris 2012 Auto Join Date: Feb 2014
Location: UK
Posts: 5
|
Norma key. it's a TR spec with touch and go. I was considering tapping the wire leading to the USB connector for the front. I don't mind rnning some power cabling from the front to the back, but if there was a ready 12V switched supply in the boot (trunk) area, it'd save on wiring.
Also, just out of interest, what is the maximum current available at the USB? The actual dash cams need 5V at 1amp, if I can use a 3 way USB splitter that would save on splicing power cables - 2xUSB for the dash cams and 1Xfor the iPod |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Car battery 12V 75AH | Josepe-sv | DIY / Maintenance / Service | 11 | 01-14-2014 02:20 PM |
| 12v power for rearview camera + monitor | azeeroth | DIY / Maintenance / Service | 14 | 11-14-2012 10:53 PM |
| 12v port modification for extra ports, USB's, etc. | tire | General Yaris / Vitz Discussion | 12 | 06-13-2011 08:45 PM |
| Good place to find constant & switched 12V behind dash? | atebit | In Car Entertainment + Electronics (audio / video / alarm) | 16 | 03-03-2009 10:40 AM |
| DIY: Discreet Mounting of 12V adaptor for the Gtech & V1 | H8SGAS | DIY / Maintenance / Service | 7 | 09-26-2006 02:50 AM |
Threaded Mode