Low beams & High beams on together?

[spiceyhotwings]

Hi Scott,
I replaced the connectors but the high beams and dash still don't light up.
Now what should I do next, could something be fried in the stalk arm?
I checked all the fuses and they look fine...which fuse runs the high beams?
The dash lights were working when I fried the high beams, but eventually the the dash went black.
In the daylight position the dash lights up but as soon as I turn on my driving lights it goes off.
If I can't get this fixed I'm seriously thinking of adding some bright off road lights to my car for extra lighting.

[CTScott]

Originally Posted by spiceyhotwings

Hi Scott,
I replaced the connectors but the high beams and dash still don't light up.
Now what should I do next, could something be fried in the stalk arm.
Which fuse runs the high beams.
If I can't get this fixed I'm seriously thinking of adding some bright off road lights to my car for extra lighting.

The same fuse does both high and low beam for each side. Make sure the high beam filament is not burned out on both bulbs. Also, have someone else click the stalk between high and low beam and listen to the little relay box behind the headlight on the passenger side for the relay to click as the lights are switched back and forth.