Time for a maintenance - Toyota Yaris Forums

Exiwolfman · 04-12-2014, 02:12 PM

You gone need new rotors and pads also clean out the sliders and slider pins/ booties use silicone base grease on sliders and pins ...less is more , u will need 17 and a 14 size wrench and also channel locks to push in the piston back in order for the new pads to fit also make sure the dust ring around piston is pushed back with it..get air out or it will rip, also air out of the booties on the sliding pins. Plus remove the rubber insert on lower pin cos it nothing but a problem lol
Make sure u clean off any rust build up on calliper sliders under the shims too and ur good to go.

Sent from my iPhone using Tapatalk

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
7-17-09 Last Day for Time Attack Event @ CFRC	SAKU	Southeast	3	07-17-2009 10:11 AM
7-17-09 Last Day for Time Attack Event @ CFRC	SAKU	Tracking, Racing, Auto-X Forum	1	07-14-2009 02:10 PM
time zones	Sodium Duck	Suggestions - Feedback - Questions	13	01-06-2009 08:23 PM
2 maintenance issues	SilverBack	DIY / Maintenance / Service	14	01-03-2009 02:37 PM

04-12-2014, 02:12 PM	#2
Exiwolfman View User's Garage Drives: 2007 Yaris Join Date: Feb 2013 Location: Wasaga beach Posts: 1,617	You gone need new rotors and pads also clean out the sliders and slider pins/ booties use silicone base grease on sliders and pins ...less is more , u will need 17 and a 14 size wrench and also channel locks to push in the piston back in order for the new pads to fit also make sure the dust ring around piston is pushed back with it..get air out or it will rip, also air out of the booties on the sliding pins. Plus remove the rubber insert on lower pin cos it nothing but a problem lol Make sure u clean off any rust build up on calliper sliders under the shims too and ur good to go. Sent from my iPhone using Tapatalk