 |
 |
|
|
|
|
06-06-2014, 09:59 AM
|
#1 |
 Drives: 2000 W Reg 1.0 CDX Yaris Join Date: May 2014
Location: UK
Posts: 6
|
Well then, I had my car taken to the garage for it's MOT/Service and also had an auto-electrician take a look at my indicator problem, it turned out that sometime in the past there had been some re-wiring done and it wasn't done properly and as a result part of the wiring had been too close to the exhaust system, this cause the insulation to melt causing the exposed wiring to earth on the bodywork so a new loom has been put in.
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| driver side A/C vent blowing hot air | Yaross | DIY / Maintenance / Service | 4 | 12-05-2011 08:51 AM |
| The Weather is HOT and the MPGs are UP! | bronsin | General Yaris / Vitz Discussion | 21 | 07-30-2011 09:16 AM |
| Hot weather and locking glove box? | Lewis | DIY / Maintenance / Service | 16 | 07-08-2011 05:13 PM |
| Hot weather cooling | bigapl | DIY / Maintenance / Service | 7 | 06-03-2011 09:25 AM |
| Best synthetic for HOT weather? | DFA | DIY / Maintenance / Service | 31 | 12-24-2008 01:04 PM |
Hybrid Mode
