 |
 |
|
|
|
|
10-22-2014, 10:57 AM
|
#1 |
  
Drives: '08 2zr swapped Vios M/T Join Date: Oct 2012
Location: Caledonia Ont.
Posts: 2,938
|
I actually looked at that exact same stripping and was thinking about doing that instead. I opted for the foam due to its ease to install. I do agree that the foam could start coming off over time however, the hood keep it pressed firmly in place and the glue on the back is surprisingly strong. I'll keep an eye on it and if it starts to come off I'll go your route
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: 10 minute engine bay detail | Razr | DIY / Maintenance / Service | 61 | 07-28-2020 03:33 PM |
| Water in engine bay ! | JudgeM | DIY / Maintenance / Service | 8 | 02-05-2014 09:24 AM |
| New Engine Bay Pics | cdydjded | Forced Induction Forum | 29 | 11-07-2010 02:26 AM |
| leaky seal on engine? oil overfill? | jeff69dini | DIY / Maintenance / Service | 23 | 06-07-2010 01:52 AM |
| Engine bay prettification project | eTiMaGo | Cosmetic Modifications (Exterior/Interior) | 14 | 04-23-2007 05:22 PM |
Hybrid Mode
