 |
 |
|
|
12-07-2014, 03:50 AM
|
#6 |
  |
I had my block done by Golden Eagle, still running strong and healthy until today.
http://www.viosturbo.com/2010/12/sta...den-eagle.html I agree with some of the posters here said, stock sleeves will hold up just fine unless you plan to make a lot of horsepower. You would rather consider upgrading your rods instead, it would be a much better investment in the long run.
__________________
454 whp, 1.7 bar boost, pump gas, water/meth. 501 whp, 2.2 bar boost, pump gas + avgas, no water/meth. www.viosturbo.com - World's first 500 WHP 1NZ-FE |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Zage Turbo Kit Install - Toyota Yaris | Focus_Sh1ft | Forced Induction Forum | 160 | 02-06-2022 09:14 PM |
| SPLASH GUARD | anahtar | DIY / Maintenance / Service | 2 | 12-21-2016 01:01 PM |
| Are These 2012-2013 Yaris FRONT Mud Guard Part Numbers? | yougojay | Cosmetic Modifications (Exterior/Interior) | 13 | 12-02-2015 07:29 PM |
| HOW STRONG IS BLOCK OS 1SZFE | Faraz_Shaikh | General Yaris / Vitz Discussion | 1 | 01-05-2011 07:49 AM |
| Block guard | Paris vvt-i | Performance Modifications | 13 | 12-19-2009 01:55 AM |
Threaded Mode