 |
 |
|
|
03-29-2015, 09:04 PM
|
#5 |
  
Drives: '08 2zr swapped Vios M/T Join Date: Oct 2012
Location: Caledonia Ont.
Posts: 2,938
|
thanks for the responses guys. I took a look at CanadianTire today and the only 30mm socket they have was a 6 point. Is a 6 point adequate for a 12 point nut, or does it increase the slippage and potential to strip? If a 12 point is highly recommended then I'll keep looking for one.
My second Q is can you just use an impact gun to remove the nut without having the pop out the indented part? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wheel Bearing Replacement (FRONT) | justjesus | DIY / Maintenance / Service | 11 | 04-26-2014 08:38 PM |
| trouble with tie rod nut | BobTheYaris | DIY / Maintenance / Service | 3 | 04-07-2014 08:08 AM |
| AXEL Nut | FrankM | DIY / Maintenance / Service | 1 | 07-13-2012 07:29 AM |
| I CANNOT get the front strut nut off | naossoan | DIY / Maintenance / Service | 10 | 05-30-2009 04:11 PM |
| How to remove the Nut on the top of the shock tower | hystria | DIY / Maintenance / Service | 29 | 12-08-2006 10:30 PM |
Threaded Mode