 |
 |
|
|
09-18-2017, 04:09 AM
|
#2 |
 
Drives: 2013 NCP130 Join Date: Nov 2015
Location: Sydney, Australia
Posts: 386
|
If you have a meter, check the voltage at the the globe when the lheadlights are on. I think you will find the Yaris headlights operate by switching to ground rather than 12 volts.
You would need to run 12 volts to the relay coil, then switch it from the headlight connection being earthed. If your relay has the switched terminals separate from the coil, you could wire the coil across the common and high beam leads of the headlight. Don't forget to also include a switch to alllow high beam to be used without the driving lights. Without this you will fail the annual rego check.
__________________
Running on standard AU 14" steel wheels (14x5 rims, 175/70R14 tyres). Added reversing camera and touch screen radio, cruise control, 16" rear wiper blade, tow bar and dash cam. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Installing Trailer Light Harness | vandallen | DIY / Maintenance / Service | 7 | 06-10-2024 10:06 AM |
| DIY (08' USDM Liftback): ESUSE Fog Light Install v2.0 | goku87 | DIY / Maintenance / Service | 127 | 02-19-2023 07:01 PM |
| 2nd accident 100% my fault in every way in almost 1.3 million miles of driving | nookandcrannycar | Off-topic / Other Cars / Everything else Discussions | 20 | 01-16-2015 08:44 PM |
| 2012 Yaris LE Check Engine Light On/Eco Light Off | 2012YarisLE | DIY / Maintenance / Service | 1 | 01-22-2014 11:29 AM |
| Fog Light Installation | chrisj | Cosmetic Modifications (Exterior/Interior) | 39 | 03-12-2011 11:08 AM |
Threaded Mode