|
04-14-2018, 09:58 AM | #1 |
Drives: Toyota Yaris 2006 Sedan Join Date: Aug 2014
Location: Australia
Posts: 24
|
How to fix sunken control panel
Hey everyone,
Own a 2006 Yaris Just wanted to ask if there’s a tutorial for fixing a sunken control panel. (ie where the controls for the windows and door locks of the driver side have depressed down) I have opened the panel up and i could see that parts of it have been chipped off which i’m assuming is from wear or tear / slamming the door hard. I have tried using epoxy to “glue” the bits together but it held up for only a week. Are there are any suggestions or a DIY on how to properly fix this or should i just get a new one outright ? |
04-15-2018, 08:56 AM | #2 |
Drives: 2007 Join Date: Feb 2014
Location: motown
Posts: 339
|
JB Weld maybe worth a try.
Best option maybe a wrecker for a used part. Good luck. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag | CTScott | DIY / Maintenance / Service | 307 | 04-04-2023 03:43 AM |
2012 Camry | Kal-El | Off-topic / Other Cars / Everything else Discussions | 26 | 10-02-2011 09:20 PM |
NEED ENGINE CHECK LIGHT CODE LIST | Attitude | Forced Induction Forum | 12 | 04-11-2011 06:38 PM |
Air control panel light out | joshb166 | DIY / Maintenance / Service | 3 | 06-11-2010 12:06 PM |
Lost coins through centre control panel | Former_Neon | General Yaris / Vitz Discussion | 9 | 10-14-2009 01:38 AM |