Clutch Low biting point

[snipsnap]

Thanks to Rich_UK I also fixed it, but in a different manner. I used only the metal hex shaft of a second hand clutch master cilinder. Just by removing the pedal I could change the original plastic shaft for the metal one. Putting the pedal back in place and building a little tension with the nut it was fixed.

https://ibb.co/9Zp2YXR

1 carefully lift up the white plastic slider (do not remove it completely)
2 provide continuous back pressure behind the joint of the plastic shaft (e.g. with a small pointed screwdriver)
3 now completely remove the white plastic slide, while maintaining pressure
4 replace the plastic shaft for the metal one, while maintaining pressure
5 now push a little harder with the metal shaft so that you can place the white slide back
6 put back the white slide

Good luck!