Billet Battery Hold Down... [pics]

[FJoel]

Originally Posted by Chris07LB

Nothing as of yet Joel.

Darn snail mail.

It didn't help that it sat on my desk for a couple weeks either I guess.

I'm pretty certain we got all the kinks out and it should slide right on there. You'll notice there are some little proto defects again, Chris. I went to a smaller endmill where the tab is machined and it vibrated on that part. No such thing will happen with the tweaked speeds and feeds for the production models. The radius tool also went a little deep and left a tiny step around the part. When we run lots we usually scrap the first one because we expect little setbacks like these until we get the offsets all tweaked out.

I can't thank you enough for your help Chris, and the idea!! I'm sorry this process has taken so long and that I wasn't more on top of communicating with you.