 |
 |
|
|
|
|
01-02-2025, 06:48 AM
|
#1 |
 Drives: 07 Yaris, Saab 900 Turbo Join Date: Jun 2009
Location: Finland
Posts: 28
|
I've now welded it up, had to remove the rear axle completely.
Right side, ended up cutting a lot more than shown here.  New bottom plate with welded nut.  2mm sheet metal, painted with zinc primer.   Left side   Used a red primer to start with but switched to the gray zinc primer.  Also treated the rear axle with penetrating rust treatment (dinitrol ml) and then brushed it with a bitumen/oil based rust proofing agent.  The whole underside and cavities are being treated with dinitrol ML right now, then I'll also apply the same bitumen and oil based stuff over that once it has dried. Car should have a few more years in it now. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW | VitzBoy | General Yaris / Vitz Discussion | 7 | 09-20-2023 08:50 AM |
| DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag | CTScott | DIY / Maintenance / Service | 307 | 04-04-2023 04:43 AM |
| Rear Passenger Area Power Outlet DIY - Sedan | fnkngrv | DIY / Maintenance / Service | 4 | 04-04-2019 08:03 AM |
| rear wiper arm delete | Giammarco36 | General Yaris / Vitz Discussion | 20 | 05-16-2010 10:03 PM |
| Dealer: Disabling the seat belt chime is now illegal? | schleppy | Cosmetic Modifications (Exterior/Interior) | 13 | 04-18-2009 05:43 PM |
Hybrid Mode
