installed zpi pulley. great mod!

[YarisGuy]

I am envious that you have such an eye capable of inspecting the material integrity of bare aluminum. Good luck to you.

.

[joey1320]

Originally Posted by YarisGuy

I am envious that you have such an eye capable of inspecting the material integrity of bare aluminum. Good luck to you.

.

ok... i know i can't visually inspect the aluminum, besides for cracks or stress marks, but the pulley looked great and i believe it will last a long long time.

people were upset with zpi due to their customer service but i got my pulley the following day after paying for it and the cs was great. sorry if you were one of the unhappy customers!

[PetersRedYaris]

Originally Posted by YarisGuy

I am envious that you have such an eye capable of inspecting the material integrity of bare aluminum. Good luck to you.

.

That statement is just plain rude (not what this forum needs ). It IS possible to inspect the craftsmanship of a machined aluminum pulley for quality with your naked eye. I had one of these in my hands before selling it on ebay. They do seem well made. In addition, because they use a centering pin, they lack the groove that cracked in the TC pulley. No, they are not anodized, not that they need to be, but they do seem well made. I'm not running any pulley for warranty issues (a whole new arguement we don't need to get into here), just saying this type of post is uncalled for.

[ism3t]

Originally Posted by YarisGuy

I am envious that you have such an eye capable of inspecting the material integrity of bare aluminum. Good luck to you.

.

i was honestly ROFLing after reading this.

quite rude , but GOD DAMN it was well spoken .

[YarisGuy]

Originally Posted by ism3t

i was honestly ROFLing after reading this.

quite rude , but GOD DAMN it was well spoken .

Just being honest and speaking factually instead of throwing out an opinion

Thank you for noticing