 |
 |
|
|
06-08-2007, 02:24 PM
|
#12 |
  Drives: 07 yaris liftback Join Date: Mar 2007
Location: NY
Posts: 220
|
my bad - i meant to put a question mark after the 4, I wasnt sure - i was guessing. Either way, after its off - you almost have to use a slide hammer to get it out of there. Its usually a little harder after its been heated up and run. If you have a narrow crow bar or something similar that is hooked on the end. You slide it in, hook it around the bottom and yank it out real good. Sorry about the bolt confusion...I'm at work - couldnt run outside to double check.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Greddy TiC exhaust For the Yaris | Invision Yaris | Sponsors Classifieds Area | 17 | 09-07-2007 05:59 PM |
| INTEREST: Greddy Exhaust for SEDAN!!! | C2AUTOSPL | Performance Modifications | 21 | 06-08-2007 08:07 PM |
| Catback Exhaust by Greddy! | elsteverino889 | Performance Modifications | 8 | 03-11-2007 12:05 AM |
| GReddy prototype = Free Exhaust! | Chris_Lum | California | 30 | 02-27-2007 11:13 PM |
| Tanabe Concept G Exhaust Installed | Toddhata | Performance Modifications | 65 | 10-06-2006 07:19 PM |
Threaded Mode