 |
 |
|
|
06-19-2007, 10:56 AM
|
#33 |
 
Drives: 2007 White Toyota Yaris Type S Join Date: Dec 2006
Location: Southern California
Posts: 439
 |
chino, if you look at the 2nd picture at the bottom of the tubing about an inch or 2 away from the filter, you can see the maf harness and plug. Thats where it is, id say its roughly 1-2 inches from the filter and that may be too close.
So what im gonna do is hack out that middle part between the vacuum line and the maf, leaving enough room on the ends for couplers, and swapping the section with the maf and the piping.... what do you think?
__________________
 TRD Springs w/ KYB Struts and Shocks, Custom CAI w/ K&N filter and pre filter wrap, Weapon R Header, Stock 15 inch alloys, Dezod Performance pads, Tanabe Front Strut Bar, 35% front door Tint and 20% Rear doors back Tint, De-Badged Ass, Custom painted flat black interior, Pioneer deh-p6700bt w/ IPOD hookup, Infinity components up front with custom mounted tweeter, Inifinity 6x9's out back, 1 12" kicker comp cvr........
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intake Systems Decision Maker.. | Blenjar | Performance Modifications | 25 | 09-15-2007 11:07 PM |
| WR Secret Weapon Intake Dyno Tested.. | WRLEO | Performance Modifications | 70 | 05-17-2007 04:00 PM |
| Intake VS modified filter housing | Spades | Performance Modifications | 19 | 03-30-2007 01:30 AM |
| WR INTAKE SYSTEM : YOU GET $100 FOR DYNO RESULTS ! | WRLEO | Sponsors Classifieds Area | 0 | 02-22-2007 11:14 AM |
| Cold Air Intake vs. Short Ram Intake | nevermorez | Performance Modifications | 1 | 01-24-2007 05:25 PM |
Threaded Mode