Chasing a Vibration - Toyota Yaris Forums

CharlieBravo · 12-23-2019, 06:54 PM

UPDATE:

Everything put back together. Fluid re-added to transmission. I'm guessing its about 0.1qt less than whatever it had at the start. Little bit spilled out before I could put the pan in place when I pulled the axle out. Little bit leaked out as I was pouring it back into the transmission. There's probably a little bit still in the pan, funnel, and tubing.

Took it for a test drive. Nothing fell apart...yet. And the noise/vibration seems to be gone! The only thing I know for sure is that the passenger bearing was failing. Making a grinding noise when free spinning the wheel and noticed grease coming out of the bearing when I pulled it out of the hub.

I guess mission accomplished for now.....

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mystery(misery?) vibration, I am determined to find a solution.	seatech30	DIY / Maintenance / Service	4	06-16-2019 07:48 PM
Excessive vibration over 60mph. Suspension related?	Aclosefriend	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	17	03-29-2016 07:06 PM
Vibration on idle & rough start	Murtaza_murti	DIY / Maintenance / Service	25	08-15-2015 01:58 PM
Yaris vibration abnormality	talhahs	DIY / Maintenance / Service	13	04-13-2013 11:07 PM
Pulsating Vibration	dbudworth	General Yaris / Vitz Discussion	5	03-28-2011 05:06 PM

12-23-2019, 06:54 PM	#6
CharlieBravo Drives: 2007 Yaris HB Join Date: Dec 2011 Location: Florida Posts: 39	UPDATE: Everything put back together. Fluid re-added to transmission. I'm guessing its about 0.1qt less than whatever it had at the start. Little bit spilled out before I could put the pan in place when I pulled the axle out. Little bit leaked out as I was pouring it back into the transmission. There's probably a little bit still in the pan, funnel, and tubing. Took it for a test drive. Nothing fell apart...yet. And the noise/vibration seems to be gone! The only thing I know for sure is that the passenger bearing was failing. Making a grinding noise when free spinning the wheel and noticed grease coming out of the bearing when I pulled it out of the hub. I guess mission accomplished for now.....