WTB: Fog light switch from the Micro Image fog light kit - Toyota Yaris Forums

swidd · 05-15-2013, 03:34 PM

Okay,.. so there are four wires going into the switch. But I only found two coming out of the harness + the ground wire. The other one must be hidden inside the harness or be merged with the red/yellow wire coming out. As I put it back together already, I'm too lazy to take it apart to check, unless it really becomes necessary. It's so hot outside...

http://i.imgur.com/MmYoWzs.jpg

http://i.imgur.com/AmcxmpE.jpg

The good news is that the fog lights are working, and the switch is working.

The bad news is that, at least as far as I can tell in super bright sunlight, the switch illumination is still on with the ignition off.

I guess I can snip the "third" red wire, i.e. the one next to the grounding wire, to resolve this issue? I don't really need switch illumination or dash light; when it's dark I can tell by looking where I'm supposed to be looking while driving, to tell if they're on.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY:Day time running light Disabled with stock fog light remain function	summergxz	DIY / Maintenance / Service	12	09-26-2007 11:42 AM
replacement fog light switch?	yrsdrgn	Cosmetic Modifications (Exterior/Interior)	4	07-17-2007 05:11 PM
Bulb Size For After Market Fog Light Kit	razzorjet2	DIY / Maintenance / Service	1	04-10-2007 03:15 PM
Reverse light vs Rear Fog light	cooldavidko	General Yaris / Vitz Discussion	3	01-03-2007 04:09 AM
question on Fog light	clfile	Cosmetic Modifications (Exterior/Interior)	6	11-09-2006 08:11 PM

05-15-2013, 03:34 PM	#20
swidd Drives: Yaris HB Join Date: Jul 2007 Location: Central Alabama, GOD BLESS AMERICA Posts: 755	Okay,.. so there are four wires going into the switch. But I only found two coming out of the harness + the ground wire. The other one must be hidden inside the harness or be merged with the red/yellow wire coming out. As I put it back together already, I'm too lazy to take it apart to check, unless it really becomes necessary. It's so hot outside... http://i.imgur.com/MmYoWzs.jpg http://i.imgur.com/AmcxmpE.jpg The good news is that the fog lights are working, and the switch is working. The bad news is that, at least as far as I can tell in super bright sunlight, the switch illumination is still on with the ignition off. I guess I can snip the "third" red wire, i.e. the one next to the grounding wire, to resolve this issue? I don't really need switch illumination or dash light; when it's dark I can tell by looking where I'm supposed to be looking while driving, to tell if they're on.