WTB: Fog light switch from the Micro Image fog light kit

[swidd]

So I have to remove the ends of the switch's wire and just tap 3 and 13... Okay :-)

I really didn't understand that from reading the manual. I'm not a smart man :-/

[CTScott]

Originally Posted by swidd

So I have to remove the ends of the switch's wire and just tap 3 and 13... Okay :-)

I really didn't understand that from reading the manual. I'm not a smart man :-/

There was always much confusion on that. It means that you need to split the switch's harness all the way to the switch, so that there are four completely separate wires, and then you need to extend some of them to reach where they need to go.

[swidd]

Now you just confused me even more. There's three wires coming out of the switch socket.

Black (which I grounded)
Green (in picture)
Red (in picture).

Where does each go? If I want to ignore the switch light and just have functional fog lights, can I stick with the instructions in 6(b) and just merge green and red to 3 and 13? And leave black grounded?

[CTScott]

Originally Posted by swidd

Now you just confused me even more. There's three wires coming out of the switch socket.

Black (which I grounded)
Green (in picture)
Red (in picture).

Where does each go?

It depends on there position in the switch connector. There should be four wires entering the green connector.