Warning - Broken control arm bolt! - Page 26 - Toyota Yaris Forums

myfirstyota · 02-13-2020, 06:17 PM

Quote:

Originally Posted by kenora

well it looks like I did some house cleaning and got rid of the steering rack bolt pics but here are the LCA bolts... the passenger side shaft has eroded (rusted away) more that the other but I'm glad I'm changing them..
If some needs to see the steering rack bolts I can take another pic ... I saved the bolts to show friends the crap Toyota put in these cars..

I'm very impressed you were able to get the rack bolts out and replaced without dropping the subframe. Or did I miss that step?

kenora · 02-24-2020, 08:56 AM

that is correct... the sub frame doesn't need to come out..

I needed to removed the drivers side inner tie rod and boot and then wiggle the rack out the passenger side.. it takes a bit of twist and turn and about 5 minutes but out she came...
on reinstall it goes in the same way... the inner tie rod is installed after the rack is back on..

ex-x-fire · 08-23-2020, 05:54 PM

I was checking the LCA bolts on a new to me 09, I got the bolts out ok, not to rusty but rusty dust fell out. The metal sleeve of the bushing seemed way over sized for the bolt. Anyone remember this being the case?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY Cruise Control FAQ (2006-2010 Yaris)	CTScott	DIY / Maintenance / Service	468	11-19-2024 03:45 PM
DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag	CTScott	DIY / Maintenance / Service	307	04-04-2023 03:43 AM
Cruise Control - Again!	CB900F2	DIY / Maintenance / Service	47	06-17-2010 06:29 PM
Cruise control vs MPG	YarisOwnersDad	Fuel Economy Forum	15	05-29-2009 03:55 PM

02-24-2020, 08:56 AM	#452
kenora Drives: 2009 Yaris LE 5 dr Join Date: Feb 2009 Location: Kenora. Ontario, Canada Posts: 45	that is correct... the sub frame doesn't need to come out.. I needed to removed the drivers side inner tie rod and boot and then wiggle the rack out the passenger side.. it takes a bit of twist and turn and about 5 minutes but out she came... on reinstall it goes in the same way... the inner tie rod is installed after the rack is back on..

08-23-2020, 05:54 PM	#453
ex-x-fire Drives: 2010 yaris 3 door hatch Join Date: Jun 2013 Location: Sheboygan Falls, Wi. Posts: 551	I was checking the LCA bolts on a new to me 09, I got the bolts out ok, not to rusty but rusty dust fell out. The metal sleeve of the bushing seemed way over sized for the bolt. Anyone remember this being the case?