Installing a remote starter without cutting factory wires? - Toyota Yaris Forums

manborn · 03-09-2009, 10:37 AM

i've installed the AST ultrastart 1155tl but are having the following issues:

1. could not locate green wire for PARKING LIGHTS in driver kick
panel, there were 2 greens - 1 (thinner wire) for o.e.m. factory
keyless unlock, while there was no voltage detected in the other
(thicker wire) when activated by remote. also checked grey(according
to yaris forums) wire in kick panel as well but no luck.

2. with factory default settings - pressed unlock or lock in remote 3
times within 3 secs but was unsuccessful with remote start.

3. remote start unit came only with purple (+) start in the 14 pin
power connector which i attached to the green o.e.m. factory keyless
disarm by the driver side kick panel, although this green wire seems
to be (+) and not (-) as indicated in the omega wiring sheet which
said it should work but did not.

I can successfully reset the remote start to factory default setting.
It also seems to be able to tach learn as well. See attached wiring setup
used.

any input would be appreciated.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Northeast DIY Remote Start / Keyless Entry Workshop - Sunday, October 26	CTScott	General Yaris / Vitz Discussion	51	11-10-2012 02:32 PM
remote starter, instaled but cant get tach sig?	karl53913	DIY / Maintenance / Service	8	11-26-2008 11:40 AM
Remote Car Starter	KittenRD	Fuel Economy Forum	6	11-08-2008 12:53 PM
starter kill & horn help	spechuy	DIY / Maintenance / Service	0	10-20-2008 02:30 PM

03-09-2009, 10:37 AM	#15
manborn are u still 34/39? View User's Garage Drives: flint mica yaris s sedan Join Date: Sep 2006 Location: bergen county, nj, us Posts: 146	i've installed the AST ultrastart 1155tl but are having the following issues: 1. could not locate green wire for PARKING LIGHTS in driver kick panel, there were 2 greens - 1 (thinner wire) for o.e.m. factory keyless unlock, while there was no voltage detected in the other (thicker wire) when activated by remote. also checked grey(according to yaris forums) wire in kick panel as well but no luck. 2. with factory default settings - pressed unlock or lock in remote 3 times within 3 secs but was unsuccessful with remote start. 3. remote start unit came only with purple (+) start in the 14 pin power connector which i attached to the green o.e.m. factory keyless disarm by the driver side kick panel, although this green wire seems to be (+) and not (-) as indicated in the omega wiring sheet which said it should work but did not. I can successfully reset the remote start to factory default setting. It also seems to be able to tach learn as well. See attached wiring setup used. any input would be appreciated.