Installing a remote starter without cutting factory wires?

[manborn]

Originally Posted by CTScott

Trunk and hood are separate. The hood switch is only present when the factory alarm is installed, otherwise you have to add the pin switch included with the remote starter.

The brake switch is either of the green wires on the connector just above the brake pedal. You can't use the brake lights, as the remote starters want a ground on brake.

that would be PERFECT since i have the toyota rs3200 factory alarm w/c means i should have a wire for the hood pin but where is it? there doesn't seem to be any pin/switch for the hood. the dash does not have any indication if the hood is open when it's open just the trunk.