DIY - 1.8L 1ZZ-FE TB Connector Chip Swap

[MGargano]

Originally Posted by AlexNet0

^no, not unless you also capped the hoses.

lol no I used one of those barb couplers. I finally broke down and did the chip swap and coolant bypass. I have the gasket maker setting overnight and look forward to testing it out tomorrow morning.

[tk-421]

Originally Posted by MGargano

lol no I used one of those barb couplers. I finally broke down and did the chip swap and coolant bypass. I have the gasket maker setting overnight and look forward to testing it out tomorrow morning.

Good luck! Hope that gets that problem solved on your end.
I'm also considering capping the (now useless) tubes... What did you use for that?

[MGargano]

Originally Posted by tk-421

Good luck! Hope that gets that problem solved on your end.
I'm also considering capping the (now useless) tubes... What did you use for that?

Just a few inches of rubber tubing with a little brass plug on the end. I found the plug's at Lowe's in the same section as the barb union coupler.