DIY: Nonstop Tuning CR-Lite Pulley

[Altitude]

Originally Posted by rhino5

So....where did the beginning of this thread get moved to? My pulley will be here tomorrow and I'm sure I'll be able to figure it out...but it'd be nice to have a reference.

I would guess it's been moved to the MicroImage forum, though I haven't checked. It's a shame Charles had to remove all of his DIY's for spite.

[WeeYari]

Originally Posted by Altitude

I would guess it's been moved to the MicroImage forum, though I haven't checked. It's a shame Charles had to remove all of his DIY's for spite.

Yes, it is on the MI forum. I went there this past Wednesday to walk myself through a NST 10% UDP.

It is a very simple DIY, especially if you have an impact wrench to remove the crank bolt. That is the only potential difficult step if you need to rely on breaker bars to loosen that sucker.