 |
 |
|
|
08-24-2010, 04:32 PM
|
#9 | |
 
Drives: 08 Yaris Turbo; 06 tC Turbo Join Date: Jan 2010
Location: New Jersey
Posts: 875
|
Quote:
 I'm ready to start the car / crank the engine, but I'm currently doing battle with Zage's pan. This thing sucks. It's barely leaking at the moment from the side of the pan where the two nuts go on, but they don't fit on the Zage pan. Even after doing some drilling to try to get them to thread the stems I've had no luck. Waiting for my silicon + JB Weld to dry and see if I finally have a seal, after having to take it off again earlier. |
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: Autometer Cobalt 6170 Boost Gauge | Nexus1155 | Items for Sale by private party | 2 | 02-02-2011 04:08 PM |
| Multiple cylinder misfire under boost | LtNoogie | Forced Induction Forum | 13 | 11-02-2009 04:44 AM |
| Fill up with Super before starting your boost project | LtNoogie | Forced Induction Forum | 5 | 12-01-2008 06:41 PM |
| Supercharger Selection and Limiting Boost | Nexus1155 | Forced Induction Forum | 1 | 12-01-2008 03:51 PM |
| WTB: Boost Gauges | Teruyume | Items for Sale by private party | 4 | 11-12-2006 02:42 PM |
Threaded Mode