how do i remove steering wheel?

[TickleTimeTim]

So ive decided to put my stock wheel back on and I know how to, however when I originally took it off I didn't tape the clock wheel well enough and it spun. What is the significance to this thing and how do i reset it?

[CTScott]

Originally Posted by TickleTimeTim

So ive decided to put my stock wheel back on and I know how to, however when I originally took it off I didn't tape the clock wheel well enough and it spun. What is the significance to this thing and how do i reset it?

It being centered is important, as otherwise when you go to full stop on one side you will snap the ribbon cable inside of it. To re-center it, turn it all the way in one direction until it stops and then turn it back 2 1/2 turns until the little triangles meet on the bottom of the face of it.

[TickleTimeTim]

You never cease to amaze. thank you. Ill try it. So I take it that it doesnt matter which way I spin it all the way too?

[TickleTimeTim]

Got it back on thanks. Now how d i get airbaf light off? Disconnect battery?

[CTScott]

Originally Posted by TickleTimeTim

Got it back on thanks. Now how d i get airbaf light off? Disconnect battery?

http://www.yarisworld.com/forums/sho...d=1#post557473

[TickleTimeTim]

You're the man. After school, before work, ill try to remove the light. This jumper wire...excuse my stupidity, but would speaker wire work? Would that bridge it okay?

[CTScott]

Originally Posted by TickleTimeTim

You're the man. After school, before work, ill try to remove the light. This jumper wire...excuse my stupidity, but would speaker wire work? Would that bridge it okay?

A paper clip or any piece of wire, of which the bare ends will fit into the holes, will work.

[TickleTimeTim]

Originally Posted by CTScott

http://www.yarisworld.com/forums/sho...d=1#post557473

Tried this but a random s/p light started flashing and my airing light did nothifng. What did i do wrong? Wrong port?

[CTScott]

Originally Posted by TickleTimeTim

Tried this but a random s/p light started flashing and my airing light did nothifng. What did i do wrong? Wrong port?

You are probably on the wring pins. You might want to try from the top of the connector (by removing the change cup). On top it is the White wire with the black stripe to the pink wire.

[CTScott]

Originally Posted by TickleTimeTim

You never cease to amaze. thank you. Ill try it. So I take it that it doesnt matter which way I spin it all the way too?

Correct - Either way you'll hit a stop. Once you do it is 2.5 turns back to center from either stop.