ok seriously need help...

[caineroad]

Originally Posted by CTScott

You typically have to move the leads to another set of holes when measuring current. 10m for current would be 10 mA, which is very little current, so you are overloading the meter. You should have the meter set to its highest current rating (which is probably only 10A).

Here is how my multi looks:
http://i49.tinypic.com/ea3vwk.jpg

Are you saying one lead goes to the gauge socket, the other lead goes to another empty socket?

I measured this was the same result as I measure from both leads to the same gauge socket

result were:
200 - 1
2000 - 1
20m - 1
200m - 36.7
10A - 0.04

So it's less than 0.04A I suppose, while the car is in ACC mode.

I hope this is the right figures? I am going to unplug the camera and put the car in reverse and see what the Amp says.