DIY - 2009 Cruise Control for $10, without pulling the steering wheel and airbag - Toyota Yaris Forums

momerath · 05-02-2009, 12:02 PM

Hello. I'm eager to try this out next week. I just have a couple of questions.

Question #1:

You stated in step 6: "Connect wires from switch assembly to wires on connector D3. Red wire from switches connects to blue wire of D3 Pin 1. Black wire from switches connects to brown wire of D3 Pin 3."

It's unclear whether or not I connect the switch assembly wires to the blue/brown wires themselves or to the connectors. The picture isn't clear because I'm not seeing the added black and red switch assembly wires. Is the picture under step 6 a before or after? It is exactly the same as the picture under step 3.

Question #2:

How do you remove the "push button start" cover? I tried playing with it to see if I could snap it off but I had no luck. It seems pretty firmly in place. I didn't want to force it too much for fear of breaking it off.

Question #3:

How easy is it to run the wire from that cover to the steering wheel assembly? Is there a direct path from the cover into the assembly?

thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OEM foglight switch and leather wrap steering wheel	808yarisLB	Cosmetic Modifications (Exterior/Interior)	8	03-11-2009 12:05 AM
SCION SPORT STEERING WHEEL, RED, XA AND XB, 03 TO 06	justoneyaris	Items for Sale by private party	3	12-04-2008 06:30 PM
steering wheel setup	aucorium	Cosmetic Modifications (Exterior/Interior)	0	07-24-2007 01:05 AM
How do you take off steering wheel	mrrock	Cosmetic Modifications (Exterior/Interior)	3	12-05-2006 10:16 AM

05-02-2009, 12:02 PM	#11
momerath I've made a post! Drives: '09 Yaris 2 door liftback Join Date: May 2009 Location: Baton Rouge, LA Posts: 1	Hello. I'm eager to try this out next week. I just have a couple of questions. Question #1: You stated in step 6: "Connect wires from switch assembly to wires on connector D3. Red wire from switches connects to blue wire of D3 Pin 1. Black wire from switches connects to brown wire of D3 Pin 3." It's unclear whether or not I connect the switch assembly wires to the blue/brown wires themselves or to the connectors. The picture isn't clear because I'm not seeing the added black and red switch assembly wires. Is the picture under step 6 a before or after? It is exactly the same as the picture under step 3. Question #2: How do you remove the "push button start" cover? I tried playing with it to see if I could snap it off but I had no luck. It seems pretty firmly in place. I didn't want to force it too much for fear of breaking it off. Question #3: How easy is it to run the wire from that cover to the steering wheel assembly? Is there a direct path from the cover into the assembly? thanks!